Monster Gel CSF Fast is the newest Prosthetic Grade Alginate from our friends at Monster Makers. This product comes from their range of new warm water set, alginates that mix easily to very creamy consistencies by hand. The CSF in the name stands for crystalline silica free. The ideal water temperature for this product is 90° Fahrenheit or 32° Celsius. The faster 2-3 minute set time allows for efficient moulding of smaller projects such as hands and face casts. Please note that this alginate should not be mixed with cold water. They are formulated to work with warm to very warm water. Cold water mixes can result in very slow and weak setting batches.
Directions:
The correct ratio is approximately 1:1. There is some variability of course, depending on the desired consistency. Keep in mind too that for the best strength, it is specifically warm water set. Ideal water temperature is around 26-32*C.
Monster Gel CSF Thick Mix – 1 Water pbw / 1 Alginate pbw
Monster Gel CSF Thin Mix – 2 Water pbw / 1 Alginate pbw
Please be mindful of the amount of material needed as the alginate will not bond to itself once cured without special bonding agents. Monster Gel CSF Fast is an organic based product and is to be used only a temporary mould material. To avoid shrinkage and distortion in castings, it is best to make a positive cast immediately. Consider our Hydrostone, Ultracal 30 or White Hydrocal gypsums, or Casting Plaster. The most Wax, plasters and wax or oil based clays below 212°F or 100°C may be poured into alginate moulds. Moulds should be immediately discarded after use.
The technical data sheet (TDS) and safety data sheet (SDS) for this or any Monster Makers product should be read before using and is available under the Technical Documents section. All Monster Makers products are safe to use if directions are read and followed carefully. Keep Out of Reach of Children.
